Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

--- joystick [2023/11/14 18:29] – [Joystick] gerald
+++ joystick [2025/10/04 17:19] (aktuell) – [ShanWan SJ@JX Gamepad] gerald
@@ Zeile 109: / Zeile 109: @@
 -buttons s x d c a z Return space
 </code>
+===== ShanWan SJ@JX Gamepad =====
+ShanWan     SJ@JX Gamepad
+Bus 001 Device 007: ID 20bc:5500 ShenZhen ShanWan Technology Co., Ltd. Frostbite controller
+  * 3D joystick for flight simulation games, Analogue Stick Thumb sticks Joystick Cap Mushroom Head.
+  * Developed for Nintendo Switch game console. DIY your Nintendo Switch controller.
+  * Suitable for PS3, Nintendo Switch, Raspberry Pi, Retropie, MAME and all windows systems!   * Hold the Mode key for 5 seconds to switch to mode.
+  * Make sure to open Pro Controller Wired Communication on the Nintendo switch settings page
+  * Size:Board 8.5cm(9cm with USB Plug) x 3.5cm. USB Cable 180cm. Button and Joystick Cable 20cm.
+**Macro commands and SOCD function. More notes on extended functionality.**
+. Press and hold the Macro button until the Macro LED flashes to start editing the Macro command.
+. Enter the key combination sequentially.
+(1) Available buttons: A, B, X, Y, L1, L2, L3, R1, R2, R3, SE, ST.
+(2) Available joysticks: up, up-left, left, down-left, down, down-right, right, up-right.
+(3) The key value is output at a fixed rate, and the time interval for inputting the key value is not recorded.
+. Short press the Macro button, the LED stops flashing, and the recording is successful.
+. Press the Macro button to sequentially output the recorded key combination.
+. For example:
+(1)Press and hold the Macro 1 button until the light flashes.
+(2)Press in sequence: left, down-left, down, A, B.
+(3)Short press the Macro 1 button, the indicator light stops flashing.
+(4)Then, short press the Macro 1 button, the encoding board will output left, down-left, down, A, B in sequence.
+. SOCD (Simultaneous Opposing Cardinal Directions):
+Preset 5 different SOCD modes.
+Select the mode you want, hold down the X, A, B and Y button, then press the select button once.
+The LED blinks a few times and then turns off, and the setting is successful.
+(1) Button X + Select:
+←+→=→, ↓+↑=↑, ←+↓+→=↓.
+(2) Button A + Select (default. Applies to most situations.):
+←+→=None, ↓+↑=None, ←+↓+→=↓.
+(3) Button B + Select:
+←+→=→, ↓+↑=↑, ←+↓+→=↘.
+(4) Button Y + Select:
+←+→=None, ↓+↑=↑, ←+↓+→=↓.
+(5) Button L1 + Select:
+←+→=←, ↓+↑=↑, ←+↓+→=↓.
+{{::joystick.jpg?600|}}

Nach oben

joystick.1699986543.txt.gz · Zuletzt geändert: 2024/02/29 13:35 (Externe Bearbeitung)

Übersicht Letzte Änderungen